Vape Cartridge tooling 101 guide
If you are comparing three quotes for vape cartridge, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.
Published 23 February 2026 · VapeWholesaleHub · Reading time 7 min
Price breaks and payment terms
We work with adult smokers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
We publish a realistic band of 1.77 to 5.46 per unit for standard configurations at 240 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.
The checks behind every shipment
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
A 0.5 percent defect rate sounds excellent until it lands on a 600 unit order and you are handling three returns in a week. We quote realistic rates per category and we credit in advance for the known failure modes.
Getting the carton there intact
For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.
Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.
- Reference sample retained from every batch
- Batch codes traceable from carton back to production date
- Document pack prepared per destination market
- Seven-day defect reporting with replace-or-credit
- Mixed SKU cartons to spread first-order risk
- Named account contact who has handled the product
What happens when something goes wrong
Technical questions usually arrive at the worst possible moment, which is why we answer them on WhatsApp as well as email. A photo and a two line message resolves most issues faster than a ticket.
Returns are handled as data, not as complaints. Every reported failure is logged by mode and by batch, and the pattern is reviewed monthly with the factory.
Specification summary
| Volume | 1.0 ml |
| Core | Ceramic |
| Resistance | 1.5 ohm |
| Thread | Press-fit |
| Airflow | Side |
| Packaging | Tube |
| Minimum order | 300 units per SKU, mixed cartons allowed |
| Lead time | 30 working days after artwork approval |
We would rather lose an order at quotation stage than explain a mismatch after delivery, which is why the specification conversation comes before the price conversation.
Frequently asked
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 240 units. We would rather you handle the sample than approve a specification from a photograph.
How long does production take?
Around 22 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
What is the minimum order for vape cartridge?
Standard configurations start at 240 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 600 units because of setup time on the line.
Related reading
Need a quotation on vape cartridges?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz