Vape Cartridge pallet and container load notes
A vape cartridge programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.
Published 18 December 2025 · VapeWholesaleHub · Reading time 5 min
Compliance without the last-minute scramble
There is no shortage of suppliers quoting vape cartridge. The scarce thing is a supplier who will tell you which SKU to drop. We have been shipping vape cartridges long enough to know that the honest answer is usually a shorter list, and that is the answer we give.
Regulation for vape cartridges differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.
Advertising rules are stricter than product rules in most markets. Claims about cessation, health or comparative performance should stay off packaging and off your product pages unless your legal team has signed them off.
Reading a quotation properly
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
What we test before a carton is sealed
A 0.5 percent defect rate sounds excellent until it lands on a 600 unit order and you are handling three returns in a week. We quote realistic rates per category and we credit in advance for the known failure modes.
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
- Reference sample retained from every batch
- Private label files archived for future rebrands
- Named account contact who has handled the product
- Artwork proof plus physical dummy for custom packaging
- Document pack prepared per destination market
- Standing reorder schedule with a fixed cut-off
Simple habits that lift velocity
Staff knowledge converts better than any poster. If your team can explain the difference between two coils in one sentence, the step-up SKU sells itself.
Counter space is finite. Three well-chosen SKUs outsell nine crowded ones, and the empty space signals a curated range rather than a clearance table.
Specification summary
| Volume | 1.0 ml |
| Core | Ceramic |
| Resistance | 1.5 ohm |
| Thread | Press-fit |
| Airflow | Bottom |
| Packaging | Tube |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 25 working days after artwork approval |
The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.
Frequently asked
What is the minimum order for vape cartridge?
Standard configurations start at 60 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 240 units because of setup time on the line.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What documents come with a shipment?
Commercial invoice, packing list, and the certificate pack for your market: test reports, declaration of conformity and safety data sheets. We send scans before dispatch so your broker can pre-clear the file.
Related reading
Need a quotation on vape cartridges?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz